Commands for Status Monitoring and Statistics
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
616
Example
The following command configures a switch to not take an action if a hardware fault occurs:
configure sys-recovery-level slot none
History
This command was first available in ExtremeWare XOS 11.3.
The
shutdown parameter was added in ExtremeWare XOS 11.5.
Platform Availability
This command is available only on modular switches.
To Next Page
Loading...