Extreme Networks ExtremeWare XOS - Page 838

ACL Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
838
The following command creates a dynamic ACL that accepts all the UDP packets from the 10.203.134.0/
24 subnet that are destined for the host 140.158.18.16, with source port 190 and a destination port in the
range of 1200 to 1250:
create access-list udpacl “source-address 10.203.134.0/24;destination-address
140.158.18.16/32;protocol udp;source-port 190;destination-port 1200 - 1250;”
“permit”
The previous example creates a dynamic ACL entry named udpacl that is equivalent to the following
ACL policy file entry:
entry udpacl {
if {
source-address 10.203.134.0/24;
destination-address 140.158.18.16/32;
protocol udp;
source-port 190;
destination-port 1200 - 1250;
} then {
permit;
}
}
History
This command was first available in ExtremeWare XOS 11.3.
Platform Availability
This command is available on all platforms.