QoS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
864
All Extreme Networks switches support the standard 802.1p priority bits that are part of a tagged
Ethernet packet.
With the 11.0 version of the software on the BlackDiamond 10808 switch, you can also assign
parameters to traffic ingressing the switch for minimum and maximum bandwidth and priority queuing
to the backplane.
Beginning with ExtremeWare XOS version 11.4, Extreme Networks introduces hardware-based
hierarchical QoS (HQoS), or rate limiting, on the BlackDiamond 12804 R-series switch. You configure
HQoS in different ways for different streams of traffic.
NOTE
You may view some CLI variables that are not supported in this release.
To Next Page
Loading...