QoS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
880
Protocol:
Trunking: Load sharing is not enabled.
EDP: Enabled
ELSM: Disabled
DLCS: Unsupported
lbDetect: Unsupported
Learning: Enabled
Unicast Flooding: Enabled
Multicast Flooding: Enabled
Broadcast Flooding: Enabled
Jumbo: Disabled
BG QoS monitor: Unsupported
High Priority COS: 7
Packet Length Adjustment: 0 bytes
QoS Profile: None configured
Aggregate Queue:
QP0 MinBw = 0% MaxBw = 75% Pri = 8
Queue:
QP1 MinBw = 0% MaxBw = 100% Pri = 1
QP2 MinBw = 0% MaxBw = 100% Pri = 2
QP3 MinBw = 0% MaxBw = 100% Pri = 3
QP4 MinBw = 0% MaxBw = 100% Pri = 4
QP5 MinBw = 0% MaxBw = 100% Pri = 5
QP6 MinBw = 0% MaxBw = 100% Pri = 6
QP7 MinBw = 0% MaxBw = 100% Pri = 7
QP8 MinBw = 0% MaxBw = 100% Pri = 8
Ingress Rate Shaping : Unsupported
Ingress IPTOS Examination: Disabled
Egress IPTOS Replacement: Disabled
Egress 802.1p Replacement: Disabled
NetLogin: Disabled
NetLogin port mode: Port based VLANs
Smart redundancy: Enabled
Software redundant port: Disabled
Preferred medium: Fiber
Example
The following command configures the egress bandwidth on port 2:5 of the BlackDiamond 12804 R-
Series switch as a maximum of 75% of the total bandwidth:
configure ports 2:5 rate-limit egress aggregate maxbw 75
History
This command was first available in ExtremeWare XOS 11.4.
Platform Availability
The command is available only on the BlackDiamond 10808 and 12804 switch.
To Next Page
Loading...