QoS Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
932
● Minimum bandwidth
● Maximum bandwidth
BlackDiamond 8800 original modules and Summit X450 series switch only. The following information
displays for these switches:
● Available Qos profiles
● Weight
● Percentage of maximum buffer
BlackDiamond 10808K and 12804 switch only. If you do not specify the variable
ingress, the system
displays the information for egress QoS values on the BlackDiamond 10808 switch (ingress is not
supported on the BlackDiamond 12804 switch).
The following information displays for the BlackDiamond 10808 and 12804 switch for each QoS profile:
● Qos profile
● Minimum bandwidth
● Maximum bandwidth
● Priority
Example
The display varies depending on your platform.
BlackDiamond 8800 a-series and e-series modules and Summit X450a and X450e series switches only. The
following sample output displays for these switches when you omit the optional
port parameter:
QP1 Weight = 1 Max Buffer Percent = 100
QP8 Weight = 1 Max Buffer Percent = 100
When you add the optional port parameter, the switch displays the following sample output:
Port: 4:1
QP1 CIR = 10M PR = 100M
QP8 MinBw = 0% MaxBw = 100%
NOTE
This last sample output is not available on the XGS2 ports.
BlackDiamond 8800 original modules and Summit X450 series switch only. No arguments are available on
the BlackDiamond 8800 original modules or the Summit X450 series switch for this command.
Following is sample output from the
show qosprofile command:
QP1 Weight = 1 Max Buffer Percent = 100
QP2 Weight = 4 Max Buffer Percent = 90
QP8 Weight = 1 Max Buffer Percent = 100
To Next Page
Loading...