UCM630X Series User Manual
Version 1.0.11.10
added in Call Features→SCA page.
CallerID number that will be used when calling out and receiving direct callbacks.
If enabled, the extension can be registered to and accessed via Wave. If disabled,
Wave cannot be used, but regular registration and calling functionality will still work.
If enabled, this extension number will be displayed in the Wave contact, otherwise, it
will not be displayed, and it cannot be found in the chat, but the user can still dial this
number.
Select voice prompt language for this extension.
If set to "Default", the global setting for voice prompt language will be used.
Use NAT when the PBX is on a public IP communicating with devices hidden behind
NAT (e.g., broadband router). If there is a one-way audio issue, usually it is related to
NAT configuration or the Firewall's support of SIP and RTP ports. The default setting
is enabled.
By default, the PBX will route the media steams from SIP endpoints through itself. If
enabled, the PBX will attempt to negotiate with the endpoints to route the media
stream directly. It is not always possible for the PBX to negotiate endpoint-to-endpoint
media routing. The default setting is "No".
Select DTMF mode for the user to send DTMF. The default setting is "RFC4733". If
"Info" is selected, the SIP INFO message will be used. If "Inband" is selected, a-law
or u-law are required. When "Auto" is selected, RFC4733 will be used if offered,
otherwise "Inband" will be used.
When present in an INVITE request, the Alert-info header field specifies an alternative
ring tone to the UAS.
Enable/disable SRTP for RTP stream encryption.
Packet Loss
Retransmission
Configure to enable Packet Loss Retransmission.
To Next Page
Loading...
Need help?
General
