UCM630X Series User Manual
Version 1.0.11.10
Note: Global inbound mode must be enabled before users can configure
route-level inbound mode
Choose the inbound mode for this route.
Note: Toggling the global inbound mode will not affect routes that have Route-
level Inbound Mode enabled. If all routes have the option enabled, toggling
the global inbound mode via BLF will trigger a voice prompt indicating that
none of the routes will be affected by the global inbound mode change.
Dial "Global Inbound Mode feature code + Inbound Mode Suffix" or a route's
assigned suffix to toggle the route's inbound mode.
The BLF subscribed to the inbound mode suffix can monitor the current
inbound mode.
Multiple mode allows users to switch between destinations of the inbound rule
by feature codes. Configure related feature codes as described in [Inbound
Route: Multiple Mode]. If this option is enabled, the user can use feature
code to switch between different modes/destinations.
This option shows up only when "By DID" is selected. If enabled, the external
users dialing into the trunk via this inbound route can dial outbound calls using
the UCM’s trunk.
This option shows up only when "By DID" is selected.
• Disable: Only the selected Extensions or Extension Groups are
allowed to use this rule when enabled Filter on Source Caller ID.
• Internal: The lowest level required. All users are allowed to use this
rule, checking this level might be risky for security purposes.
• Local: Users with Local level, National or International level are
allowed to use this rule.
• National: Users with National or International Level are allowed to
use this rule.
• International: The highest level required. Only users with an
international level are allowed to use this rule.
To Next Page
Loading...
