Configure System Information
57
M4300 Series and M4300-96X Fully Managed Switches User Manual
10. Specify the IP Subnet Mask for the interface. This is also referred to as the subnet/network
mask and defines the portion of the interface’s IP address that is used to identify the
attached network.
The factory default value is 255.255.0.0.
11. Specify the Gateway for the management VLAN interface.
The factory default value is 0.0.0.0.
12. In the Reset IPv4 Management Interface section of the page, use the Set Management
Interface to Default option to set the IPv4 management interface to the default VLAN 1.
13. Click the Apply button.
Your settings are saved.
The Current IPv4 Management Interface Status is displayed at the bottom of the page.
The table below describes the nonconfigurable fields.
Table 15. Nonconfigurable IPv4 Management Interface Status
Field Description
Management Interface Displays the current IPv4 management interface
Link State Indicates whether the link status is up or down.
Routing Interface Status Indicates whether the link status is up or down for the management
interface.
MAC Address The MAC address assigned to the management interface.
IP Address Configuration Method Indicates whether the IP address configuration method is DHCP or
manual.
IP Address The IP address of the management interface.
To Next Page
Loading...
