Configure System Information
58
M4300 Series and M4300-96X Fully Managed Switches User Manual
Configure an IPv6 Management VLAN
To configure IPv6 Management, you have the choice to configure IPv6 Management using
the same VLAN as is used for IPv4 Management or using a different VLAN. IPv6
Management configuration is non-default and you need to create it manually.
To configure an IPv6 management VLAN:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select System > Management > Management Interfaces > IPv6 Management VLAN
Configuration.
6. In the Management VLAN ID field, specify the Management VLAN ID of the switch.
The
management VLAN is used for management of the switch.
The VLAN ID can be any value
from 1 to 4093. There is no IPv6 management interface configured by default.
7. Select the IPv6 Enable Mode radio button to Enable or Disable the administration mode
for the management VLAN IPv6 interface on the switch.
Subnet Mask The IP subnet mask for the management interface.
Gateway The specified default gateway for the management interface.
Table 15. Nonconfigurable IPv4 Management Interface Status
Field Description
To Next Page
Loading...
