Getting Started
R&S
®
SMW200A
88User Manual 1175.6632.02 ─ 16
How to display all parameters with values different to their preset values
When you load a file to your instrument, you may do not have enough information on
the changed settings. In such case, it is useful to visualize all parameters that have
been changed from their default state.
Try out the following:
●
Tap and hold on an empty space in the block diagram to access the context-sensi-
tive menu.
●
Select "Mark all parameters changed from preset".
●
All changed parameters are highlighted.
See also Chapter 10, "File and Data Management", on page 619.
Trying Out the Instrument
To Next Page
Loading...
