Getting Started
R&S
®
SMW200A
87User Manual 1175.6632.02 ─ 16
3. Tap the "Save" button.
The file MyTestSignal.savrcltxt is stored in the default directory /var/
user.
To load stored instrument settings
You can restore the settings to the instrument at any time using the settings file.
1. Press the PRESET button to restore the default instrument settings so you can
check that the stored user settings are restored afterwards.
2. Press the SAVE/RCL key.
3. In the "Save/Recall" dialog, select "Recall" operation.
Navigate to the directory the file is stored in and select the MyTestSignal file.
4. Tap the "Recall" button.
All instrument settings are restored and the display resembles Figure 2-12, which
shows the instrument display right before the settings were stored.
Trying Out the Instrument
To Next Page
Loading...
