Remote Control Commands
R&S
®
SMW200A
1139User Manual 1175.6632.02 ─ 16
Parameters:
<Event> string
Example:
:STAT:OPER:EVEN?
queries the STATus:OPERation:EVENt register.
:STATus:OPERation:NTRansition <Ntransition>
Sets the bits of the NTRansition part of the STATus:OPERation register. If a bit is set,
a transition from 1 to 0 in the condition part causes an entry to be made in the EVENt
part of the register. The disappearance of an event in the hardware is thus registered,
for example the end of an adjustment.
Parameters:
<Ntransition> string
Example:
:STAT:OPER:NTR 0
a transition from 1 to 0 in the condition part of the Status:Opera-
tion register does not cause an entry to be made in the EVENt
part.
:STATus:OPERation:PTRansition <Ptransition>
Sets the bits of the PTRansition part of the STATus:OPERation register. If a bit is set,
a transition from 0 to 1 in the condition part causes an entry to be made in the EVENt
part of the register. A new event in the hardware is thus registered, for example the
start of an adjustment.
Parameters:
<Ptransition> string
Example:
:STAT:OPER:PTR 32767
all transitions from 0 to 1 in the condition part of the Status:Oper-
ation register cause an entry to be made in the EVENt part.
:STATus:PRESet <Preset>
Resets the status registers. All PTRansition parts are set to FFFFh (32767), i.e. all
transitions from 0 to 1 are detected. All NTRansition parts are set to 0, i.e. a transition
from 1 to 0 in a CONDition bit is not detected. The ENABle parts of STATus:OPERa-
tion and STATus:QUEStionable are set to 0, i.e. all events in these registers are not
passed on.
Parameters:
<Preset> string
Example:
STAT:PRES
resets the status registers.
STATus Subsystem
To Next Page
Loading...
