Elements and Controls of the Graphical User Interface
R&S
®
SMW200A
1224User Manual 1175.6632.02 ─ 16
Overload
The power of the external signal applied to the RF output is too high. The overload pro-
tection has tripped and the connection between the RF output and attenuator interrup-
ted.
To activate RF input, reset the overload protection with the RF ON/OFF key.
External Reference Frequency
Indicates a used external reference signal and the frequency of the signal.
Access to the "Ext. Ref.\LO Coupling" tab in the "RF Frequency / Phase ..."
dialog.
Modulation
Indicates that the RF signal is modulated.
Access to the "I/Q Modulator" and "Analog Modulation" dialogs.
Sweep
Indicates that either the RF or LF signal is generated in sweep mode.
Access to the "Sweep" settings.
Busy
Indicates a running process, that means, settings or calculations are currently execu-
ted. If a process takes some time, the button displays the progress as a percentage.
Recording
Indicates that recording is running.
Access to the "SCPI Sequence" dialog.
Lev
Label of the level entry filed of the corresponding RF path.
Access to the "RF Level..." dialog.
Level Offset & Level EMF Offset & Level Ucor & Level Digital Attenuation
This icon is displayed when you use functions or parameters that affect the RF output
level. The icon appears instead of Lev.
The label varies according to:
●
A specified level offset ("Offs")
●
The level displayed as voltage of EMF ("EMF")
●
An activated user correction ("Ucor")
●
A specified digital attenuation ("DigAtt")
If several settings are enabled, the symbol label combines the appropriate information
according to the order and relevance.
Access to the "RF Level / EMF ... " dialog.
<RF level>
Entry field for directly setting the RF level.
Elements in the Status Bar
To Next Page
Loading...
