Signal Routing and System Configuration
R&S
®
SMW200A
195User Manual 1175.6632.02 ─ 16
Figure 3-16: Signal routing example (Fading and Baseband Configuration > 1x4x4 and Coupled
Baseband Sources)
To define the baseband signal
To generate an EUTRA/LTE signal, use the following general steps:
1. Select "Baseband > EUTRA/LTE".
2. Configure the settings as required.
For example, enable "EUTRA/LTE > Link Direction > Downlink".
Select a "DL Test Model > E-TM1.1 5MHz"
3. Select "EUTRA/LTE > State > On" to enable signal generation.
4. In the status bar, select "Frequency A = Frequency B = 2.1432 GHz" and "Lev A =
Lev B = -60 dBm".
How to Connect External Instruments and Configure the Signal Flow
To Next Page
Loading...
