Signal Routing and System Configuration
R&S
®
SMW200A
200User Manual 1175.6632.02 ─ 16
8. Select "Apply".
The "System Config > System Configuration > External RF und I/Q" dialog displays
the settings of the connected external instrument.
9. You can disable "RF Couple" state and adjusts the RF settings manually.
In a MIMO setup however, it is useful to use the coupled settings, because a MIMO
setup typically requires the same RF frequency at all antennas.
10. Perform the previous steps to connect and configure the second R&S SGS.
11. Select "I/Q OUT 1 > External Instrument > Config".
a) Select "External Instrument Configuration > Initialization Sequence".
b) Select "Initialization Sequence > Predefined Settings".
Select the predefined initialization file external_reference_10MHz.
How to Connect External Instruments and Configure the Signal Flow
To Next Page
Loading...
