Signal Routing and System Configuration
R&S
®
SMW200A
201User Manual 1175.6632.02 ─ 16
Tip: Try out also "To create a remote control sequence or modify the initialization
sequence" on page 207.
12. In the "System Config > System Configuration > External RF und I/Q" dialog, select
the "I/Q OUT 1 > Rem Conn" icon to toggle the state.
This action establishes the remote connection to the instrument.
Figure 3-18: Example: Connecting external instruments to the I/Q OUT 1/2 of theR&S
SMW
(2xR&S
SGS)
The R&S SMW:
● Sends a :DEV:PRES command to the connected external instrument
● Triggers the external instrument to execute the configuration defined in the initi-
alization sequence file
● Adjusts the RF settings of the external instrument, e.g. applies the same RF
frequency at both RF outputs and at the RF outputs of the external instruments.
How to Connect External Instruments and Configure the Signal Flow
To Next Page
Loading...
