Configuring the Signal in the RF Domain
R&S
®
SMW200A
536User Manual 1175.6632.02 ─ 16
3. Select "Edit Cor. Data > Edit > Fill With Sensor".
This dialog contains parameters for filling a table automatically with sensor read-
ings.
Settings are interdependent, the affected parameters change accordingly if you set a
value.
To fill the table, select "Execute".
For information on power sensors an how to use them, see Chapter 7.8.5, "How to Cal-
ibrate the Power Level with an R&S NRP Power Sensor", on page 553.
Settings
Fill User Correction Data with Sensor......................................................................... 537
Used SMW Settings For Measurement.......................................................................537
Improving Level Performance
To Next Page
Loading...
