Configuring the Signal in the RF Domain
R&S
®
SMW200A
537User Manual 1175.6632.02 ─ 16
Fill User Correction Data with Sensor
●
"Sensor"
Displays connected sensors for selection.
●
"List To Fill"
Indicates the used list.
●
"Include Zeroing"
Performs a zeroing procedure before acquiring the user correction data to improve
precision.
No signal may be applied to the sensor during zeroing. RF output is temporarily
switched off during that time.
When unchecked, the zeroing procedure is skipped. However, the RF signal level
might be blanked shortly. This setting is useful if blanking of RF is undesirable or
the absence of power at the sensor cannot be guaranteed.
●
"Execute"
The "Execute" button is only enabled if a sensor is detected and the user correction list
contains at least one frequency value.
Remote command:
[:SOURce<hw>]:CORRection:ZERoing:STATe on page 1030
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe
on page 1029
Used SMW Settings For Measurement
Displays the settings relevant for the measurement.
"RF Source"
Shows the path for which the correction menu settings are made.
"Modulation"
Indicates the modulation state
"Amplitude"
Shows the currently set level.
"Use SParameter"
Indicates whether SParameter correction is used.
"Attenuator Mode Path 1"
Displays the selected mode of the attenuator.
"Level range"
Shows the level range.
Remote command:
n.a.
Improving Level Performance
To Next Page
Loading...
