Configuring the Signal in the RF Domain
R&S
®
SMW200A
557User Manual 1175.6632.02 ─ 16
10. Select "Save" to save the data in the file.
11. Close the dialog.
To perform power leveling calibration with user correction data
We assume that a user correction file is available in the user directory of the
R&S SMW or on a memory stick or in a shared directory.
If you have created and saved the file immediately before this step, the file is loaded in
the "User Correction" dialog automatically. Otherwise you can load a previously saved
file.
1. Select "RF" > "RF Level" > "User Correction".
2. Select "UCOR Data > User Cor. Data", if there is no file loaded already.
3. Select the directory and file you want to use.
4. Load the file with "Select".
5. To view the file content, select "Edit User Cor. Data".
Improving Level Performance
To Next Page
Loading...
