Network Operation and Remote Control
R&S
®
SMW200A
715User Manual 1175.6632.02 ─ 16
In the "Network" dialog, you can configure the settings of the general network envi-
ronment and specific identification parameters of the instrument in the network.
The remote commands required to configure the network remotely are described in
Chapter 13.19, "SYSTem Subsystem", on page 1115.
How to connect the signal generator to the network is described in the Chapter 2.1.4,
"Setting Up a Network (LAN) Connection", on page 45.
Network Status
Indicates that the instrument is connected to the network.
Remote command:
:SYSTem:COMMunicate:NETWork:STATus? on page 1126
Hostname
Displays the hostname.
Each instrument is delivered with an assigned hostname, a logical name which can be
used instead of the IP address. With the default network settings, the IP address is
allocated by the DHCP server. This address can change each time the instrument is
reconnected. Unlike the IP address, the hostname name does not change.
Note:
Remote Access Settings
To Next Page
Loading...
