Network Operation and Remote Control
R&S
®
SMW200A
755User Manual 1175.6632.02 ─ 16
c) Select "Show SCPI List".
The list of all SCPI commands is displayed for example for a final check.
Exporting the SCPI list of the instrument state in one step is a fast and convenient
method. Nevertheless, it usually requires postprocessing on an external PC.
How to check an SCPI list
The easiest way to check a list is to execute it. The generator returns a warning if a
setting could not be performed.
However, we recommend that you check the list and possibly rework. It can be that ...
●
A parameter has not assigned an SCPI command or an element of the user inter-
face has not an assigned parameter. In these cases, :SYST:INF:SCPI 'SCPI
command not available' is entered in the list instead.
Such entries are also detected during execution. The instrument recognizes these
incomplete commands and displays an error message.
●
A preset has been executed, but several standards subsequently perform some
internal settings that are also assigned to the list with "SCPI Export".
●
After a preset still some settings are defined, which are then written to the list gen-
erated with "SCPI Export."
Some suggestions on how you can check and revise a list:
1. Search and remove missing command entries.
2. Remove unnecessary content that has been written after a preset.
How to Record / Create SCPI Lists
To Next Page
Loading...
