Remote Control Commands
R&S
®
SMW200A
844User Manual 1175.6632.02 ─ 16
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: see Example "Distributing the I/Q streams to the output connec-
tors (advanced configuration)" on page 826
Manual operation: See "Auto Connect" on page 149
:SCONfiguration:EXTernal:REMote:CONNect[:ALL]
:SCONfiguration:EXTernal:REMote:DISConnect[:ALL]
Triggers the instrument to establish the connections to all configured external RF and
I/Q instruments or to disconnect all existing connections.
Example:
see Example "Connecting and configuring external instrument
(advanced configuration)" on page 826
Usage: Event
Manual operation: See "Connect/Disconnect All Remote" on page 149
:SCONfiguration:EXTernal:PBEHaviour <State>
If enabled, the connection to the external instruments is retained on instrument's preset
(*RST).
Parameters:
<State> 0 | 1 | OFF | ON
*RST: n.a. (factory preset: 0)
SCONfiguration Subsystem
To Next Page
Loading...
