Rohde & Schwarz SMW200A - Page 963

Remote Control Commands
R&S
®
SMW200A
948User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CLOad
Creates a multi-carrier waveform using the current entries of the carrier table and acti-
vates the ARB generator.
Use the command [:SOURce<hw>]:BB:ARBitrary:MCARrier:OFILe to define
the multi-carrier waveform file name. The file extension is *.wv.
Example: See Example "Generating a multi carrier signal" on page 926
Usage: Event
Manual operation: See "Create/Create and Load" on page 364
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CLOCk?
Queries the resulting sample rate at which the multi-carrier waveform is output by the
arbitrary waveform generator. The output clock rate depends on the number of carri-
ers, carrier spacing, and input sample rate of the leftmost or rightmost carriers.
Return values:
<Clock> float
Range: 400 to Max
Increment: 1E-3
Example:
BB:ARB:MCAR:CLOC?
Queries the ARB multi-carrier output clock rate.
Usage: Query only
Manual operation: See "Clock Rate" on page 364
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CREate
Creates a multi-carrier waveform using the current settings of the carrier table.
Use the command [:SOURce<hw>]:BB:ARBitrary:MCARrier:OFILe to define
the multi-carrier waveform file name. The file extension is *.wv.
Example:
See Example "Generating a multi carrier signal" on page 926
Usage: Event
Manual operation: See "Create/Create and Load" on page 364
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:STATe <State>
Enables/diasbled the selected carrier.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Generating a multi carrier signal" on page 926
SOURce Subsystem