Rohde & Schwarz SMW200A - Page 999

Remote Control Commands
R&S
®
SMW200A
984User Manual 1175.6632.02 ─ 16
SOURce:BB:MCCW:STATe ON
// Enable signal generation
OUTPut ON
// Enable the signal output
// ******************************************************************
// Storing the current settings
// ******************************************************************
:MMEMory:MDIR '/var/user/savrcl'
// Create a new directory "savrcl"
*SAV 4
:MMEMory:STORe:STATe 4,"/var/user/savrcl/mccw_SSB.savrcltxt"
// Store the current settings in an intermediate memory with number 4
// Store the settings file in the specified directory; the complete path
// and filename has to be specified
To visualize the configured signal, switch to local mode with the command &NREN and
open the "Multi-carrier Continuous Wave > Carrier Graph".
Generating a multi-carrier signal to test the image rejection of an SSB filter
This example generates a multi-carrier single sideband signal as shown in Fig-
ure 13-12.
Figure 13-12: Multi-carrier signal to test the image rejection of an SSB filter
SOURce Subsystem