C613-50055-01 REV A Command Reference for x230 Series Edge Switches 107
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
FILE MANAGEMENT COMMANDS
Valid characters The filename and path can include characters from up to four categories. The
categories are:
1) uppercase letters: A to Z
2) lowercase letters: a to z
3) digits: 0 to 9
4) special symbols: all printable ASCII characters not included in the previous
three categories. Including the following characters:
•-
•/
•.
•_
•@
•"
•'
•*
•:
•~
•?
Do not use spaces or parentheses within filenames. Use hyphens or underscores
instead.
Syntax for
directory listings
A leading slash (/) indicates the root of the current filesystem location.
In commands where you need to specify the local filesystem’s Flash base directory,
you may use flash or flash: or flash:/. For example, these commands are all the
same:
• dir flash
• dir flash:
• dir flash:/
Similarly, you can specify the SD (or SDHC) card base directory with card or card:
or card:/
You cannot name a directory or subdirectory flash, nvs, usb, card, tftp, scp, sftp
or http. These keywords are reserved for tab completion when using various file
commands.
Command List •“autoboot enable” on page 110
•“boot config-file” on page 111
•“boot config-file backup” on page 113
•“boot system” on page 114
To Next Page
Loading...
Need help?
General
