C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1507
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
PING-POLLING COMMANDS
SHOW
PING-POLL
Status The current status of the device being polled:
Up The device is reachable.
Down The device is unreachable.
Critic
a l Up
The device is reachable but recently the polling
instance has not received some ping replies, so the
polled device may be going down.
Critic
a l
Down
The device is unreachable but the polling instance
received a reply to the last ping packet, so the
polled device may be coming back up.
Enabled Whether the polling instance is enabled or disabled. The active
(ping-polling) and active (ping-polling) commands enable and
disable a polling instance.
Source IP
address
The source IP address sent in the ping packets. This is set using
the source-ip command.
Critical
interval
The time period in seconds between pings when the polling
instance has not received a reply to at least one ping, and when
the device is unreachable. This is set with the critical-interval
command.
Normal
interval
The time period between pings when the device is reachable.
This is set with the normal-interval command.
Fail count The number of pings that must be unanswered, within the total
number of pings specified by the sample-size command, for the
polling instance to consider the device unreachable. This is set
using the fail-count command.
Up count The number of consecutive pings that the polling instance must
receive a reply to before classifying the device reachable again.
This is set using the up-count command.
Sample size The total number of pings that the polling instance inspects
when determining whether a device is unreachable. This is set
using the sample-size command.
Length The number of data bytes to include in the data portion of the
ping packet. This is set using the length (ping-poll data)
command.
Timeout The time in seconds that the polling instance waits for a
response to a ping packet. This is set using the timeout (ping
polling) command.
Debugging Indicates whether ping polling debugging is Enabled or
Disabled.
This is set using the debug ping-poll command.
Table 45-4: Parameters in output of the show ping-poll command (cont.)
Parameter Description
To Next Page
Loading...
Need help?
General
