C613-50055-01 REV A Command Reference for x230 Series Edge Switches 853
AlliedWare Plusâ„¢ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
AUTH
DYNAMIC-VLAN-CREATION
If you issue an auth dynamic-vlan-creation command without an optional rule
parameter and a required deny or permit keyword value then a second supplicant
with a different VLAN ID is rejected. It is not assigned to the first supplicant’s VLAN.
Issuing an a uth dynamic-vlan-creation command without an optional rule
parameter has the same effect as issuing an auth dynamic-vlan-creation rule
deny command rejecting supplicants with differing VIDs.
The type parameter specifies whether multiple different VLANs can be assigned to
supplicants attached to the port, or whether only a single VLAN can be assigned to
supplicants on the port. The type parameter can select the port base VLAN or the
MAC base VLAN from the RADIUS VLAN ID. This can be used when the host-mode
is set to multi-supplicant. For single-host ports, the VLAN ID will be assigned to the
port. It is not supported with the Guest VLAN feature. Display the ID assigned using
a show vlan command. For multi-host ports, the VLAN ID will be assigned to the
MAC address of the authenticated supplicant. The VLAN ID assigned for the MAC
Base VLAN is displayed using the show platform table vlan command.
To configure Dynamic Vlan with Web Authentication, you need to set Web
Authentication Server virtual IP address by using the auth-web-server ipaddress
command or the auth-web-server dhcp ipaddress command. You also need to
create a hardware access-list that can be applied to the switch port interface.
You need to configure an IPv4 address for the VLAN interface on which Web
Authentication is running.
Examples To enable the Dynamic VLAN assignment feature on interface port1.0.2, use
the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# switchport access vlan 10
awplus(config-if)# auth-web enable
awplus(config-if)# auth dynamic-vlan-creation
awplus(config-if)# interface vlan10
awplus(config-if)# ip address 10.1.1.1/24
To enable the Dynamic VLAN assignment feature with Web Authentication on
interface port1.0.2 when Web Authentication is needed, use the commands:
awplus# configure terminal
awplus(config)# auth-web-server ipaddress 1.2.3.4
awplus(config)# access-list hardware acl-web send-to-cpu ip any
1.2.3.4
awplus(config)# interface port1.0.2
awplus(config-if)# auth-web enable
awplus(config-if)# auth dynamic-vlan-creation
awplus(config-if)# access-group acl-web
awplus(config-if)# interface vlan1
awplus(config-if)# ip address 10.1.1.1/24
To Next Page
Loading...
Need help?
General
