Extreme Networks ExtremeWare XOS - Page 1855

show pim
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1855
Global Packet Statistics (In/Out)
C-RP-Advs 0 0
Registers 0 0
RegisterStops 0 0
VLAN Cid IP Address Designated Flags Hello J/P Nbrs
Router Int Int
side 3 21.1.1.2 /24 21.1.1.2 rifms----S 30 60 1
v1 1 10.1.1.1 /24 10.1.1.3 rifms--n-S 30 60 1
v2 2 12.1.1.1 /24 12.1.1.1 rifms----S 30 60 0
Legend: J/P Int: Join/Prune Interval
Flags : r - Router PIM Enabled, i - Interface PIM Enabled, f - Interface,
Forwarding Enabled, m - Interface Multicast Forwarding Enabled,
s - Sparse mode, d - Dense mode, c - CRP enabled,
t - Trusted Gateway configured, n - Multinetted VLAN,
p - Passive Mode, S - Source Specific Multicast.
The following command displays the detailed PIM configuration and statistics:
show pim detauk
The following is sample output from the command:
PIM Enabled, Version 2
PIM CRP Disabled
BSR state : ACCEPT_ANY ; BSR Hash Mask Length: 255.255.255.252
Current BSR Info : 0.0.0.0 (Priority 0)
Configured BSR Info : 0.0.0.0 (Priority 0)
CRP Adv Interval : 60 sec ; CRP Holdtime: 150
BSR Interval : 60 sec ; BSR Timeout : 130
Cache Timer : 210 sec ; Prune Timer : 210
Assert Timeout : 210 sec ; Register Suppression Timeout,Probe: 60, 5
Generation Id : 0x42dc282b
Threshold for Last Hop Routers: 0 kbps
Threshold for RP : 0 kbps
Register-Rate-Limit-Interval : Always active
PIM SSM address range : 232.0.0.0/8
Register Checksum to include data
Active Sparse Ckts 3 Dense Ckts 0
Global Packet Statistics (In/Out)
C-RP-Advs 0 0
Registers 0 0
RegisterStops 0 0
PIM SPARSE Interface[3] on VLAN side is enabled and up
IP adr: 21.1.1.2 mask: 255.255.255.0 DR of the net: 21.1.1.2
Passive : No
Hello Interval : 30 sec
Neighbor Time out : 105 sec
Join/Prune Interval : 60 sec
Join/Prune holdtime : 210 sec
Trusted Gateway : none
CRP group List : none with priority 0
Shutdown priority : 1024