IP Multicast Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1856
Source Specific Multicast : Enabled
Neighbor IP address Generation Id Expires
21.1.1.1 0x42dbd7f3 77
Packet Statistics (In/Out)
Hellos 8 9 Bootstraps 0 0
Join/Prunes 0 4 Asserts 0 0
Grafts 0 0 GraftAcks 0 0
The following command displays the PIM configuration and statistics for the VLAN side:
show pim side
The following is sample output from the command:
PIM SPARSE Interface[3] on VLAN side is enabled and up
IP adr: 21.1.1.2 mask: 255.255.255.0 DR of the net: 21.1.1.2
Passive : No
Hello Interval : 30 sec
Neighbor Time out : 105 sec
Join/Prune Interval : 60 sec
Join/Prune holdtime : 210 sec
Trusted Gateway : none
CRP group List : none with priority 0
Shutdown priority : 1024
Source Specific Multicast : Enabled
Neighbor IP address Generation Id Expires
21.1.1.1 0x42dbd7f3 77
Packet Statistics (In/Out)
Hellos 8 9 Bootstraps 0 0
Join/Prunes 0 4 Asserts 0 0
Grafts 0 0 GraftAcks 0 0
The following command displays the elected, active RP for the group 239.255.255.1:
show pim rp-set 239.255.255.1
The following is sample output from the command:
Group Mask C-RP Origin Priority
224.0.0.0 240.0.0.0 10.10.10.2 Bootstrap 0
224.0.0.0 240.0.0.0 124.124.124.124 Bootstrap 0
224.0.0.0 240.0.0.0 124.124.124.124 static 0
239.255.255.0 255.255.255.0 124.124.124.124 Bootstrap 0
Elected RP is 124.124.124.124
History
This command was first available in ExtremeWare XOS 10.1.
The PIM-SSM information was added in ExtremeWare XOS 11.4.
To Next Page
Loading...