Extreme Networks ExtremeWare XOS - Page 404

Commands for Configuring Slots and Ports on a Switch
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
404
The following example shows sample output from the show ports utilization command for all
ports on the Summit X450 series switch (real-time display that constantly refreshes):
Link Utilization Averages Fri Aug 5 13:23:45 UTC 2005
Port Link Receive Peak Rx Transmit Peak Transmit
Status packets/sec packets/sec packets/sec packets/sec
================================================================================
1 A 0 0 0 0
2 R 0 0 0 0
3 R 0 0 0 0
4 R 0 0 0 0
5 R 0 0 0 0
6 R 0 0 0 0
7 R 0 0 0 0
8 R 0 0 0 0
9 R 0 0 0 0
10 R 0 0 0 0
11 R 0 0 0 0
12 R 0 0 0 0
13 R 0 0 0 0
14 R 0 0 0 0
15 R 0 0 0 0
16 R 0 0 0 0
17 R 0 0 0 0
================================================================================
Link Status : A-Active, R-Ready, NP-Port Not Present
Spacebar->toggle screen U->page up D->page down ESC->exit
NOTE
Use the <spacebar> to toggle this real-time display for all ports from packets to bytes and bandwidth, in that order.
The following example shows sample output from the show ports utilization bandwidth
command:
Port Link Link Receive Peak Rx Transmit Peak Transmit
Status Speed % bandwidth % bandwidth % bandwidth % bandwidth
================================================================================
1 A 1000 0.00 0.00 0.00 0.00
2 R 0 0.00 0.00 0.00 0.00
3 R 0 0.00 0.00 0.00 0.00
4 R 0 0.00 0.00 0.00 0.00
5 R 0 0.00 0.00 0.00 0.00
6 R 0 0.00 0.00 0.00 0.00
7 R 0 0.00 0.00 0.00 0.00
8 R 0 0.00 0.00 0.00 0.00
9 R 0 0.00 0.00 0.00 0.00
10 R 0 0.00 0.00 0.00 0.00
11 R 0 0.00 0.00 0.00 0.00
12 R 0 0.00 0.00 0.00 0.00
13 R 0 0.00 0.00 0.00 0.00
14 R 0 0.00 0.00 0.00 0.00
15 R 0 0.00 0.00 0.00 0.00
16 R 0 0.00 0.00 0.00 0.00
17 R 0 0.00 0.00 0.00 0.00
18 R 0 0.00 0.00 0.00 0.00