Extreme Networks ExtremeWare XOS - Page 405

show ports utilization
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
405
19 R 0 0.00 0.00 0.00 0.00
20 R 0 0.00 0.00 0.00 0.00
21 R 0 0.00 0.00 0.00 0.00
22 R 0 0.00 0.00 0.00 0.00
23 R 0 0.00 0.00 0.00 0.00
24 R 0 0.00 0.00 0.00 0.00
25 R 0 0.00 0.00 0.00 0.00
26 R 0 0.00 0.00 0.00 0.00
================================================================================
Link Status : A-Active, R-Ready, NP-Port Not Present
The following example shows sample output of the show ports utilization bytes command:
Port Link Receive Peak Rx Transmit Peak Transmit
Status bytes/sec bytes/sec bytes/sec bytes/sec
================================================================================
1 A 0 0 0 0
2 R 0 0 0 0
3 R 0 0 0 0
4 R 0 0 0 0
5 R 0 0 0 0
6 R 0 0 0 0
7 R 0 0 0 0
8 R 0 0 0 0
9 R 0 0 0 0
10 R 0 0 0 0
11 R 0 0 0 0
12 R 0 0 0 0
13 R 0 0 0 0
14 R 0 0 0 0
15 R 0 0 0 0
16 R 0 0 0 0
17 R 0 0 0 0
18 R 0 0 0 0
19 R 0 0 0 0
20 R 0 0 0 0
21 R 0 0 0 0
22 R 0 0 0 0
23 R 0 0 0 0
24 R 0 0 0 0
25 R 0 0 0 0
26 R 0 0 0 0
================================================================================
Link Status : A-Active, R-Ready, NP-Port Not Present
The following example shows sample output of the show ports utilization packets command:
Port Link Receive Peak Rx Transmit Peak Transmit
Status packets/sec packets/sec packets/sec packets/sec
================================================================================
1 A 0 0 0 0
2 R 0 0 0 0
3 R 0 0 0 0
4 R 0 0 0 0
5 R 0 0 0 0
6 R 0 0 0 0
7 R 0 0 0 0