Commands for Status Monitoring and Statistics
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
604
SysContact: support@extremenetworks.com, +1 888 257 3000
System MAC: 00:04:96:1F:A2:60
SysHealth check: Enabled (Normal)
Recovery Mode: None
System Watchdog: Enabled
If you use the strict parameter, which configures the switch to take the action configured by the
configure sys-recovery-level slot or the configure sys-recovery-level switch command,
(Strict) would appear next to Enabled.
Example
On the BlackDiamond 8800 series switch, the following command configures the switch to forward
faults to be handled by the level set by the
configure sys-recovery-level slot command:
configure sys-health-check all level strict
On the Summit X450 family of switches, the following command configures the switch to forward faults
to be handled by the level set by the
configure sys-recovery-level switch command:
configure sys-health-check all level strict
History
This command was first available in ExtremeWare XOS 11.5.
Platform Availability
This command is available only on the BlackDiamond 8800 series and the Summit X450 family of
switches.
To Next Page
Loading...