19.10.1.4 Scenario 3
• Software sets EMACO_MRO[RXE] =
o.
•
The
RXMAC component of the Ethernet MAC sub-block completes on-going activity and then sets
EMACO_MRO[RXI] = 1 to enter the related Idle state.
• Software detects EMACO_MRO[RXI] = 1.
• Software performs the necessary EMAC configuration, keeping EMACO_MRO[RXE] =
O.
The
software can access only part of EMAC registers marked with write access mode R
in
Table 19-5,
"EMAC Register Summary," on page 19-23.
• After all configuration is done, software can set EMACO_MRO[RXE] = 1.
Note: When Scenario 3 occurs, EMAC can still transmit packets if EMACO_MRO[TXE] = 1. Scenarios
2 and 3 can occur simultaneously.
19-46
PPC405GP User's Manual Preliminary