Rohde & Schwarz SMW200A - Page 1004

Remote Control Commands
R&S
®
SMW200A
989User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:PHASe........................................................... 992
[:SOURce<hw>]:BB:MCCW:CARRier:POWer................................................................... 993
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:POWer........................................................... 993
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe[:STARt]...............................................994
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer[:STARt]...............................................994
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe:STEP................................................. 994
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer:STEP................................................. 994
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STARt............................................................995
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP.............................................................995
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STATe........................................................... 995
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:EXECute........................................................ 995
[:SOURce<hw>]:BB:MCCW:PRESet
Sets all multi carrier signal parameters to their default values.
Example:
See "Programming Examples" on page 983
Usage: Event
Manual operation: See "Set to Default" on page 375
[:SOURce<hw>]:BB:MCCW:STATe <State>
Enables/disables the multi carrier CW signal.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See "Programming Examples" on page 983
Manual operation: See "State" on page 374
[:SOURce<hw>]:BB:MCCW:CARRier:COUNt <Count>
Sets the number of carriers in the multi carrier CW signal.
Parameters:
<Count> integer
Range: 1 to 160001
*RST: 64
Example: see "Programming Examples" on page 983
Manual operation: See "Number of Carriers" on page 375
[:SOURce<hw>]:BB:MCCW:CARRier:SPACing <Spacing>
Sets the carrier spacing.
SOURce Subsystem