Rohde & Schwarz SMW200A - Page 1075

Remote Control Commands
R&S
®
SMW200A
1060User Manual 1175.6632.02 ─ 16
Manual operation: See "User Variation" on page 183
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:GDELay:CSTate <CompState>
Enables/disables group delay compensation.
Parameters:
<CompState> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce:IQ:OUTPut:DIGital:BBMM1:GDELay:CSTate
Manual operation: See "Group Delay Compensation" on page 184
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:OFLow:STATe?
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:OFLow:STATe?
Queries whether the I/Q output signal is clipped or not.
Return values:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
:SOURce:IQ:OUTPut:DIGital:BBMM2:OFLow:STATe?
Response: "0" (no overflow).
Usage: Query only
Manual operation: See "Signal Monitoring" on page 183
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:OFLow:HOLD:RESet
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:OFLow:HOLD:RESet
Resets the overflow hold state and LED.
Example:
:SOURce:IQ:OUTPut:DIGital:BBMM2:OFLow:HOLD:
RESet
Usage: Event
Manual operation: See "Signal Monitoring" on page 183
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:OFLow:HOLD:STATe?
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:OFLow:HOLD:STATe?
Queries an overload since last reset for evaluating the measurement.
Return values:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
:SOURce:IQ:OUTPut:DIGital:BBMM2:OFLow:HOLD:
STATe?
SOURce Subsystem