Rohde & Schwarz SMW200A - Page 289

Configuring the Internal Baseband Source
R&S
®
SMW200A
274User Manual 1175.6632.02 ─ 16
Settings:
Modulation Type..........................................................................................................274
Load User Mapping.....................................................................................................274
ASK Depth.................................................................................................................. 275
FSK Deviation............................................................................................................. 275
Angle Alpha.................................................................................................................275
FSK Type.................................................................................................................... 275
Deviation xxxx.............................................................................................................275
State Modulation <=> CW Switching...........................................................................276
Modulation Type
Selects a modulation type. The associated symbol mapping is displayed.
If the selected "Coding" is not allowed with the configured modulation type, the value of
the parameter Coding is set to "Off".
Refer to Table 4-12 for an overview of the allowed combinations.
Remote command:
[:SOURce<hw>]:BB:DM:FORMat on page 900
Load User Mapping
Accesses the "Select List File User Mapping" dialog to select the mapping table (see
"User mapping" on page 247). The dialog provides all standard file management func-
tions.
Remote command:
[:SOURce<hw>]:BB:DM:MLISt:SELect on page 913
[:SOURce<hw>]:BB:DM:MLISt:CATalog? on page 913
[:SOURce<hw>]:BB:DM:MLISt:DELete on page 914
Generating Custom Digital Modulated Signals