Rohde & Schwarz SMW200A - Page 446

Configuring the Signal in the RF Domain
R&S
®
SMW200A
431User Manual 1175.6632.02 ─ 16
In the "RF Frequency" dialog, you can configure:
● RF frequency, incl. an offset or multiplication factor of a downstream instrument
● The step size for varying the frequency with the rotary knob.
The remote commands required to define the settings are described in Chap-
ter 13.18.6, "SOURce:FREQuency Subsystem", on page 1037.
Settings
Frequency................................................................................................................... 431
Offset...........................................................................................................................432
Multiplier......................................................................................................................432
Converter Mode.......................................................................................................... 432
User Variation............................................................................................................. 433
└ Variation Active.............................................................................................433
└ Variation Step............................................................................................... 433
Frequency
Sets the RF frequency.
This frequency is output at the RF A/RF B connector. It does not consider an Offset or
multiplication factor (Multiplier).
See Chapter 7.3.4.1, "Displayed RF Frequency and Level Values with Downstream
Instruments", on page 440.
Note: Suppressed values in the status bar
Configuring RF Frequency and Level