Network Operation and Remote Control
R&S
®
SMW200A
753User Manual 1175.6632.02 ─ 16
2. To selectively record your steps:
a) Set the parameter.
b) Open the context-sensitive menu.
c) Select "Add SCPI Command to Recording List"
Tip: You cannot see "Add SCPI ..." in the menu?
This may happen if you open it outside of a dialog or input field, for example in
block diagram. Open the context-sensitive menu within the corresponding dia-
log or input field, and the feature is available.
d) Continue with the next setting, and repeat steps a to b whenever needed.
Each time you select "Add SCPI ...", the SCPI command is appended to a tempo-
rary list.
3. To check the progress of the recording, select "Context-Sensitive > Show SCPI
Recording List".
The "SCPI Recording List" dialog opens, displaying all recorded settings so far.
4. Proceed with How to check an SCPI list.
How to Record / Create SCPI Lists
To Next Page
Loading...
