Rohde & Schwarz SMW200A

To Next Page

To Previous Page

Remote Control Commands

R&S

SMW200A

836User Manual 1175.6632.02 ─ 16

:SCONfiguration:MODE

FAABFBN | FANFBAB | FAABFBAB

ADVanced MIMO1X2 | MIMO2X2 | MIMO2X3 | MIMO2X4 | MIMO3X2

MIMO4X4 | MIMO1X8 | MIMO8X1 | MIMO2X8 | MIMO8X2

MIMO2X1X4 | MIMO2X2X2 | MIMO1X3 | MIMO3X1 |

MIMO1X4 | MIMO4X1 | MIMO3X1X2 | MIMO3X2X1 |

MIMO4X1X2 | MIMO3X2X2 | MIMO4X2X2 | MIMO4X2X1 |

SISO2X1X1 | SISO3X1X1 | SISO4X1X1 | SISO5X1X1 |

SISO6X1X1 | SISO7X1X1 | SISO8X1X1 | MIMO2X2X4 |

MIMO2X4X2 | MIMO2X2X3 | MIMO2X3X1 | MIMO2X3X2 |

MIMO2X4X1

MIMO4X8 | MIMO8X4 | MIMO2X4X4 | MIMO2X3X3|

MIMO2X3X4 | MIMO2X4X3

MIMO8X8

Parameters:

MIMO2X2X1 | MIMO2X2X2 | MIMO1X3 | MIMO3X1 |

MIMO1X4 | MIMO4X1 | MIMO3X1X2 | MIMO3X2X1 |

MIMO4X1X2 | MIMO3X2X2 | MIMO4X2X2 | MIMO4X2X1 |

SISO3X1X1 | SISO4X1X1 | SISO5X1X1 | SISO6X1X1 |

SISO7X1X1 | SISO8X1X1 | MIMO2X2X4 | MIMO2X4X2 |

MIMO4X8 | MIMO8X4 | MIMO2X1X3 | MIMO2X1X4 |

MIMO2X2X3 | MIMO2X3X1 | MIMO2X3X2 | MIMO2X4X1 |

MIMO2X4X4 | MIMO2X3X3 | MIMO2X3X4 | MIMO2X4X3 |

MIMO8X8

*RST:

FAAFBB

Example: See Example "Distributing the I/Q streams to the output connec-

tors (advanced configuration)" on page 826.

Options: LxMxN configurations with L > 2 require option R&S SMW-K76

Higher order MIMO configurations require option R&S SMW-K75

MIMO8X8 requires R&S SMW-K821

Manual operation: See "Signal Routing" on page 141

:SCONfiguration:MIMO:SUBSet <Subset>

Sets the MIMO subset.

While sumulating a 8x8 MIMO mode with two R&S SMW, the MIMO subset defines

which fading channels from the MIMO matrix are calculated by the selected instument.

The MIMO subset selected in each of the two connected instrument has to be different.

SCONfiguration Subsystem

Rohde & Schwarz SMW200A - Page 851