Getting Started
R&S
®
SMW200A
74User Manual 1175.6632.02 ─ 16
Figure 2-9: Signal mapping to the global connectors
The "Global Connectors" dialog displays the current connectors configuration. The
settings are configurable, but in this example we use the default mapping.
3. Alternatively, select "Block Diagram > Baseband > Misc > Custom Digital Mod",
select the "> Trigger In" tab and select "Local Connector Settings" or "Global Con-
nector Settings".
In the current mapping, the three global connectors USER X on the front panel are
configured as follows:
● "Marker 1/2" are output at the USER 1/2 connectors
● The USER 3 connector is an input for the "Global Trigger 1" signal.
Check the front panel of the R&S SMW. The USER 1/2 LEDs are yellow; the USER
3 LED is green.
Find the physical location of each connector
Use the built-in "Trigger Marker Clock > Show " function to display the location of the
selected connector. A blinking LED on the front/rear panel also indicates the selected
connector.
Trying Out the Instrument
To Next Page
Loading...
