General Configuration Command Set
Downloading a Firmware Image
3-52 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Defaults
If noreboot is not specified, the device will reboot automatically using the new
image.
Command Type
Switch command.
Command Mode
Read-Write.
hostname |
ip_address
Specifies the host name or IP address of the TFTP server
from which the new image file will be downloaded.
filename Specifies the TFTP server path and file name of the new
image.
noreboot (Optional) Specifies that the device will not reboot after
completing the download of an image file. The device
will continue using the existing firmware image and will
store the new image in FLASH memory. The next time
the device is reset or powered-up, it will boot from
FLASH memory using the new image.
To Next Page
Loading...
Need help?
General