VLAN Configuration Command Set
Reviewing Existing VLANs
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-3
7.3 VLAN CONFIGURATION COMMAND SET
7.3.1 Reviewing Existing VLANs
Purpose
To see a list of the current VLANs configured on the device, their VLAN type, the VLAN attributes
related to one or more ports, and the ports on a VLAN egress list. The device uses the VLAN egress
list to keep track of all VLANs that it will recognize. Depending on the command used, you can see
a list of all VLANs (dynamic and static) or just the static VLANs.
Commands
The commands needed to configure Static VLANs are listed below and described in the associated
section as shown.
• show vlan (Section 7.3.1.1)
• show vlan static (Section 7.3.1.2)
• show vlan portinfo (Section 7.3.1.3)
7.3.1.1 show vlan
Use this command to display all information related to a specific VLAN or all VLANs known to
the device (static and dynamic).
show vlan [detail] [vlan-list | vlan-name]
NOTE: Static VLANs are those VLANs created manually -- using the commands
described in this section, SNMP, or WebView.
To Next Page
Loading...
Need help?
General