EasyManuals Logo

Enterasys 1G58x-09 User Manual

Enterasys 1G58x-09
808 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
General Configuration Command Set
Setting Basic Device Properties
3-30 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.2.2 Setting Basic Device Properties
Purpose
To display and set the basic system (device) information, including password, system time, system
prompt, contact name, terminal output, lockout time, timeout, console baud rate and version
information, to display or set the system IP address, and to download a new firmware image to the
device.
Commands
The commands needed to set basic system information are listed below and described in the
associated section as shown.
• show system resources (Section 3.2.2.1)
• show time (Section 3.2.2.3)
• set time (Section 3.2.2.4)
• set prompt (Section 3.2.2.5)
• show banner motd (Section 3.2.2.6)
• set banner motd (Section 3.2.2.7)
• clear banner motd (Section 3.2.2.8)
• show version (Section 3.2.2.9)
• set system name (Section 3.2.2.10)
• set system location (Section 3.2.2.11)
• set system contact (Section 3.2.2.12)
• show terminal (Section 3.2.2.13)
• set terminal (Section 3.2.2.14)
• set system timeout (Section 3.2.2.15)
• set console baud (Section 3.2.2.21)
• show ip address (Section 3.2.2.22)
• set ip address (Section 3.2.2.23)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Enterasys 1G58x-09 and is the answer not in the manual?

Enterasys 1G58x-09 Specifications

General IconGeneral
BrandEnterasys
Model1G58x-09
CategoryNetwork Hardware
LanguageEnglish