SNMP Command Set
Configuring SNMP Notification Parameters
5-56 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
About SNMP Notify Filters
Profiles indicating which targets should not receive SNMP notification messages are kept in the
NotifyFilter table. If this table is empty, meaning that no filtering is associated with any SNMP
target, then no filtering will take place. “Traps” or “informs” notifications will be sent to all
destinations in the SNMP targetAddrTable that have tags matching those found in the NotifyTable.
When the NotifyFilter table contains profile entries, the SNMP agent will find any filter profile
name that corresponds to the target parameter name contained in an outgoing notification message.
It will then apply the appropriate subtree-specific filter when generating notification messages.
5.2.7.9 show snmp notifyfilter
Use this command to display SNMP notify filter information, identifying which profiles will not
receive SNMP notifications.
show snmp notifyfilter [profile subtree oid]
Syntax Description
Command Defaults
If no parameters are specified, all notify filter information will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
profile subtree oid (Optional) Displays a notify filter within a specific
subtree.
To Next Page
Loading...
Need help?
General