SNMP Command Set
Configuring SNMP Users, Groups and Communities
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-17
• If remote is not specified, the user will be registered for the local SNMP
engine.
• If storage type is not specified, nonvolatile will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create a new SNMP user named “netops” with MD5 authentication and
privacy encryption:
5.2.2.3 clear snmp user
Use this command to remove a user from the SNMPv3 security-model list.
clear snmp user user [remote remote]
Syntax Description
Command Defaults
If remote is not specified, the user will be removed from the local SNMP engine.
Command Type
Switch command.
Command Mode
Read-Write.
Matrix>set snmp user netops authentication md5 privacy
Matrix>Enter authentication password>***********
Matrix>Reenter authentication password>***********
Matrix>Enter privacy password>***********
Matrix>Reenter privacy password>***********
user Specifies an SNMPv3 user to remove.
remote remote (Optional) Removes the user from a specific remote
SNMP engine.
To Next Page
Loading...
Need help?
General