General Configuration Command Set
Managing Switch Configuration Files
3-62 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
This example shows how to schedule an NVRAM update by appending the clitxt.txt configuration
file in two hours:
3.2.5.4 summaryconfig
Use this command to display the Matrix E1 non-default configuration to the console, or, by entering
the file keyword, write it to the swfile.cfg file.
summaryconfig [file]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
If file is not specified, the configuration will be displayed to the console.
Matrix>configure clitxt.txt append in 02:00
file (Optional) Writes the configuration to the scfile.cfg. This
file can then be displayed using the show config command,
or uploaded to a file or a server using the copy command.
To Next Page
Loading...