Enterasys 1G58x-09 - Configuring SNMP Users, Groups and Communities

SNMP Command Set
Configuring SNMP Users, Groups and Communities
5-14 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
5.2.2 Configuring SNMP Users, Groups and Communities
Purpose
To review and configure SNMP users, groups and communities. These are defined as follows:
• User — A person registered in SNMPv3 to access SNMP management.
• Group — A collection of users who share the same SNMP access privileges.
• Community — A name used to authenticate SNMPv1 and v2 users.
Commands
The commands needed to review and configure SNMP users, groups and communities are listed
below and described in the associated section as shown.
• show snmp user (Section 5.2.2.1)
• set snmp user (Section 5.2.2.2)
• clear snmp user (Section 5.2.2.3)
• show snmp group (Section 5.2.2.4)
• set snmp group (Section 5.2.2.5)
• clear snmp group (Section 5.2.2.6)
• show community (Section 5.2.2.7)
• set community (Section 5.2.2.8)
• clear community (Section 5.2.2.9)
• show snmp community (Section 5.2.2.10)
• set snmp community (Section 5.2.2.11)
• clear snmp community (Section 5.2.2.12)