Port Configuration Command Set
Configuring Unknown Destination Address Suppression
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 4-75
4.3.15.3 clear port unknowndestsuppress
Use this command to reset the suppression of unknown unicast traffic transmission from one or
more ports to the default state of disabled.
clear port unknowndestsuppress [port-string]
Syntax Description
Command Defaults
If port-string is not specified, status of all ports will be reset.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset unknown destintation address suppression on Fast Ethernet front
panel port 1 to disabled:
port-string (Optional) Resets status for specific port(s).For a detailed
description of possible port-string values, refer to
Section 4.1.2.
Matrix>clear port unknowndestsuppress fe.0.1
To Next Page
Loading...