EasyManuals Logo

Enterasys 1G58x-09 User Manual

Enterasys 1G58x-09
808 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #86 background imageLoading...
Page #86 background image
General Configuration Command Set
Setting Basic Device Properties
3-38 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.2.2.10 set system name
Use this command to configure a name for the system.
set system name [“name_string”]
Syntax Description
Command Defaults
If name_string is not specified, the system name will be set to a blank string.
Command Type
Switch command.
Command Mode
Read-Write.
Usage Guidelines
None.
Table 3-5 show version Output Details
Output What It Displays...
Slot Fixed front panel or expansion module slot location
designation. For details on how slots are numbered, refer to
Section 4.1.2.
Ports Number of ports in the fixed front panel or expansion
module.
Model Model number of the chassis or expansion module.
Serial Number Serial number (if applicable) of the chassis or expansion
module.
HW Version Hardware version number (if applicable) of the chassis or
expansion module.
FW Version Current firmware version number (if applicable).
name_string (Optional) Specifies a text string that identifies the system.
A name string containing a space in the text must be
enclosed in quotes as shown in the example below.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Enterasys 1G58x-09 and is the answer not in the manual?

Enterasys 1G58x-09 Specifications

General IconGeneral
BrandEnterasys
Model1G58x-09
CategoryNetwork Hardware
LanguageEnglish