Enterasys 1G58x-09 - Show Spantree Autoedge

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-27
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the bridge forward delay to 15 seconds:
6.2.1.27 show spantree autoedge
Use this command to display the status of automatic edge port detection.
show spantree autoedge
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the status of the automatic edge port detection function:
Matrix>clear spantree fwddelay
Matrix>show spantree autoedge
autoEdge is currently enabled.